bx cable definition

The gold armored soldiers were supposed to be the elite of the Saturian armed forces, with equipment and weapons parallel to that of the Alliance Marines. The other family with extraordinary bacteriomes is Diaspididae, the armored scale insects. The musket also ended the dominance of the armored knights on horseback.

Read our editorial process to learn more about how we fact-check and keep our content accurate, reliable, and trustworthy. In addition, while home improvement stores still do carry BX cable, do-it-yourselfers will find a far greater selection of NM cables at retail outlets. In addition to her journalism experience, she has been educating on health and wellness topics for over 15 years in and outside of the classroom.

Ripping Back Bx Cable

BX cables are safer and protect against any accidental penetrations. Romex cables have vinyl sheathing that you can penetrate easily. A BX cable usually is grounded through an internal plastic-coated ground wire or metal armor. If the fiber-optic cable in a system needs extra protection, there is an alternative to using conduit or a bonded and grounded conductive cable, such as an all-dielectric armored cable.

bx cable definition

The first number indicates the gauge of the wire.You choices are typically 10, 12, or 14 gauge. EMT is also called “thin-wall” conduit becauseit is thin and lightweight, especially compared to RMC. EMTis rigid but can be bent with a simple tool called a conduitbender.

What Does Bx Cable Mean?

As home inspectors we see a lot of wiring in locations that need protection. Many common areas I find unprotected wiring are in closets and cabinets.

Electrical cable options vary widely, with unique types used in specific applications. Therefore, choosing the right type of cable is one of the essential tasks installers need to take on before initiating a project.

  • So “BX”is defined as “AC” cable and “MC” is defined as Metal Cladcable.
  • Wiring in locations that are subject to “physical damage” will need protection.
  • The actual name for it is “Armored Cable” or AC, but many people call it by its original trade name “Greenfield” or just BX.
  • When the cut is nearly through, grab the cable jacket above and below the cut and twist sharply – this should break the remaining armor without the need for the saw to contact the wires inside.
  • However, if the installation is out in the open, the Romex wire must be run through a conduit.

Armored cable and metal clad cable provide a fast and efficient way of wiring both new construction and remodeling work. Their flexible metal armor provides mechanical protection of the electrical conductors while enabling bx cable definition them to bend around corners. NM and NMC conductors are composed of two or more insulated conductors contained in a non-metallic sheath. The coating on NMC cable is non-conducting, flame-resistant and moisture-resistant.

BX cable’s metal sheathing can be hard to cut without nicking or severing the inner wire. But because the outer sheathing is softer, less force is required to cut it. After you insert the cable into the tool’s groove, you turn the handle to cause the cutting wheel to cut away the metal sheathing. The tool is calibrated to cut the metal but stops short of touching the inner wires.

Swa Bs 6724 Cable

Armored cable shall contain the fiber count with 12 fibers per buffer tube as shown on the Plans. Armored cable will only be allowed for concealed branch circuit wiring within the demised premises. The junction box must be kept accessible (not covered with drywall, etc.). The definition for no. 1 heavy melting is wrought iron and/or steel scrap 1/4 inch and over in thickness. Individual pieces not over 60 x 24 inches prepared in a manner to insure compact charging, as specified by the Institute of Scrap Recycling Industries.

bx cable definition

BX cable comprises plastic-coated insulated wires of about 12- or 14-gauge rolled up together and protected using a ribbon-like metal sheathing. You might hear them being otherwise called MC, type AC, armored cable, Greenfield, and metallic sheathed cable. BX CableNM CableRippingBX is difficult to rip back without a special tool.NM is far easier to rip back. Better yet, use a special armored cable cutting tool.NM cable can be cut with a lineman’s pliers or even with the cutter on a wire stripper.CodeBX is accepted by the National Electrical Code . Older BX cables without an internal bonding strip are not accepted by NEC.NM cable is also accepted by the NEC. BX’s metal sheathing runs in a helix-like or twisted manner around the wires.

If there is damage, you may need to try again by moving back and redoing another cut. Steel wire armoured cable, commonly abbreviatedas SWA, is a hard-wearing power cable designed for thesupply of mains electricity. It is one of a number ofarmoured electrical cables – which include 11 kVCable and 33 kV Cable – and is found inunderground systems, power networks and cableducting. The smaller cables should be unsheathed by using an armored cutter like the famous “Roto-Split”.

Conduit Or No Conduit

Put a BX connector on the end of the cut armor and then tighten the screw for you to secure the armor. Unless otherwise permitted, Type AC cable shall be secured within 300 mm (12 in.) of every outlet box, https://personal-accounting.org/ junction box, cabinet, or fitting and at intervals not exceeding 1.4 m (41/2 ft). Type AC cable shall be protected in accordance with 300.4, , and where installed through or parallel to framing members.

Unless otherwise permitted, Type AC cable shall be supported at intervals not exceeding 1.4 m (41/2 ft). Bends in Type AC cable shall be made such that the cable is not damaged. The radius of the curve of the inner edge of any bend shall not be less than five times the diameter of the Type AC cable. You must — there are over 200,000 words in our free online dictionary, but you are looking for one that’s only in the Merriam-Webster Unabridged Dictionary. Infoplease is part of the Sandbox Learning family of educational and reference sites for parents, teachers and students. Infoplease is a reference and learning site, combining the contents of an encyclopedia, a dictionary, an atlas and several almanacs loaded with facts. Our editors update and regularly refine this enormous body of information to bring you reliable information.

What Is The Difference Between Bx And Mc Cable?

A common stylecable that is rated for wet locations is a standard MCCable with a PVC jacket. Teck 90-HL armoured and jacketed cablesare suitable for exposed or concealed wiring in wet or drylocations where cables are subject to the risk of mechanicaldamage and chemical abuse.

MC connectors are specially designed for low contact resistance and good stable connections under a wide range of conditions. MC means “multi-contact.” The term “multi-contact” comes from the fact that the connectors have a bunch of little spring loaded gold plated fingers that ensure good contact. If you are visiting our English version, and want to see definitions of Basic Armored Cable in other languages, please click the language menu on the right bottom. You will see meanings of Basic Armored Cable in many other languages such as Arabic, Danish, Dutch, Hindi, Japan, Korean, Greek, Italian, Vietnamese, etc.

bx cable definition

In addition to these considerations, make sure you comply with the NEC first before you initiate a wiring project. Looking to those codes can help guide your choice in wiring and save you trouble in the long run. You can easily find spools of BX cable up to 1,000 feet long. The actual gauge for your project will depend upon the length and the operating load to be fed at the far end. Energize and test the circuit.Schedule any necessary “final” inspection. Add any required cable supports (e.g., staples, clamps, brackets).

What Is A Mc Cable?

While ROMEX® is available in a number of sizes, the insulated wires are all white, black and red. With conduit, you can pull two yellow wires from a switch to a light fixture.

The dissipated heat from knob-and-tube wiring can pose a fire hazard if the wires are enveloped in building insulation. A possible exception is fiberglass insulation, which is fire-resistant, although even this type of insulation should not cover knob-and-tube wiring. The homeowner or an electrician should carefully remove any insulation that is found surrounding KT wires. BX is among the earliest electrical cables designed for commercial and residential uses in the early 20th century.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>